Go to the documentation of this file.
13 #ifndef DT_CONFIG_BTI_H
14 #define DT_CONFIG_BTI_H
61 inline float ST()
const {
return (
float)(0.75 *
ST43() + 0.25 *
RE43()); }
void setLL(int LL)
Set K left limit for left traco.
void setAccPattACH(int ACH)
Set Acceptance pattern ACH.
int LH() const
K right limit for left traco.
bool RONflag() const
Redundant patterns flag RONDTBti/src/DTBtiChipEquations.cc:
~DTConfigBti() override
Destructor.
void setKAccTheta(int KAccTh)
Set BTI angular acceptance in theta view.
void setRL(int RL)
Set K left limit for right traco.
void setRONflag(bool RON)
Set Redundant patterns flag RONDTBti/src/DTBtiChipEquations.cc:
int RH() const
K right limit for right traco.
void setLH(int LH)
Set K right limit for left traco.
void setCL(int CL)
Set K left limit for center traco.
int CH() const
K right limit for center traco.
void setST43(int ST43)
Set ST and RE parameters for drift velocity.
void setSET(int SET)
Set SET.
void setLTS(int LTS)
Set LTS.
BitArray< 32 > m_pattmask
void setDefaults(const edm::ParameterSet &ps)
Set default parameters.
int PTMSflag(int patt) const
Pattern mask flag.
int KCut() const
Max K param accepted: max bit number.
int element(const int pos) const
bool XON() const
X-patterns flag XON: activates tracks passing on the same side of 3 wires.
void setDEADpar(int DEAD)
Wire DEAD time parameter.
void setPTMSflag(int mask, int patt)
Set Pattern mask flag.
void print() const
Print the setup.
void setAccPattACL(int ACL)
Set Acceptance pattern ACL.
void setKCut(int KCut)
Set Max K param accepted: max bit number.
int CL() const
K left limit for center traco.
int AccPattACL() const
Acceptance pattern ACL.
void setCH(int CH)
Set K right limit for center traco.
int AccPattAC2() const
Acceptance pattern AC2.
void setXON(bool XON)
Set X-patterns flag XON: activates tracks passing on the same side of 3 wires.
int RL() const
K left limit for right traco.
void setAccPattAC2(int AC2)
Set Acceptance pattern AC2.
int debug() const
Debug flag.
DTConfigBti()
Empty Constructor.
float ST() const
Max drift time in 12.5 ns steps.
int KAccTheta() const
BTI angular acceptance in theta view.
void setAccPattAC1(int AC1)
Set Acceptance pattern AC1.
int LL() const
K left limit for left traco.
int DEADpar() const
Wire DEAD time parameter.
int AccPattACH() const
Acceptance pattern ACH.
void setWENflag(int mask, int wire)
Set Wire mask flag.
int WENflag(int wire) const
Wire mask flag.
int AccPattAC1() const
Acceptance pattern AC1.
void setRH(int RH)
Set K right limit for right traco.
int ST43() const
ST and RE parameters for drift velocity.