DTTTrigSyncFromDB.h

Go to the documentation of this file.

#ifndef RecoLocalMuon_DTTTrigSyncFromDB_H
#define RecoLocalMuon_DTTTrigSyncFromDB_H

#include "CalibMuon/DTDigiSync/interface/DTTTrigBaseSync.h"


class DTLayer;
class DTWireId;
class DTT0;
class DTTtrig;


namespace edm {
  class ParameterSet;
}

class DTTTrigSyncFromDB : public DTTTrigBaseSync {
public:
  DTTTrigSyncFromDB(const edm::ParameterSet& config);

  ~DTTTrigSyncFromDB() override;

  // Operations

  void setES(const edm::EventSetup& setup) override;


  double offset(const DTLayer* layer,
            const DTWireId& wireId,
            const GlobalPoint& globPos,
            double& tTrig,
            double& wirePropCorr,
            double& tofCorr) override;

  double offset(const DTWireId& wireId) override;


  double emulatorOffset(const DTWireId& wireId,
                double &tTrig,
                double &t0cell) override;


 private:
  
  const DTT0 *tZeroMap;
  const DTTtrig *tTrigMap;
  // Set the verbosity level
  const bool debug;
  // The velocity of signal propagation along the wire (cm/ns)
  double theVPropWire;
  // Switch on/off the T0 correction from pulses
  bool doT0Correction;
  // Switch on/off the TOF correction for particles from IP
  bool doTOFCorrection;
  int theTOFCorrType;
  // Switch on/off the correction for the signal propagation along the wire
  bool doWirePropCorrection;
  int theWirePropCorrType;
  // spacing of BX in ns
  double theBXspace;

  std::string thetTrigLabel;

};
#endif